Home > News >

How To Install High-Speed Bearings

wallpapers News 2020-07-20

Installation and adjustment of high-speed bearings:

Both high-precision bearings require coordination and clearance of high-speed bearings Since high-speed bearings and high-temperature bearings, and the following two points must be considered when considering their coordination and removal:

1. Dimensional change and hardness change from average temperature too high temperature;

2. Changes in force system and shape caused by centrifugal force at high speed.

In short, under the conditions of high speed and high temperature, it is difficult to maintain the accuracy and working performance of the bearing from the choice of fit and clearance.

To ensure that the deformation of the raceway after the bearing is installed is small, the interference of the interference fit cannot be made too large, and the centrifugal force at high speed and the thermal expansion at a high temperature can offset the normal pressure of the mating surface. Or to loosen the mating surface, the interference must be calculated carefully considering the above two factors. The active intervention at standard temperature and speed may not be valid for high-speed bearings.

Thermal expansion at high temperatures may offset the average pressure on the mating surface. Or to loosen the mating surface, the interference must be calculated carefully considering the above two factors. The active intervention at standard temperature and speed may not be useful for high-speed bearings. When considering the clearance of high-speed bearings, not only the above factors should be considered, but also the influence of the thermal elongation of the shaft on approval, the bearing must be in working condition, that is, the clearance at the operating temperature. The gap is formed with the center of the inner and outer ring grooves aligned. Because high-speed bearings strive to reduce relative sliding and internal friction, do not use the method of relative displacement of the inner and outer rings in the axial direction to adjust the clearance of the ball bearings.


Tag: FAG Bearing   High-Speed B